In case if usb cable drivers are not installed automatically. Go through following Path for manual driver installation.

For All Operating System
(Windows XP, Windows Vista, Windows 7)

1) Explore the following path.
	C:\Program Files\GENIE-NX\G-SOFT NX II\USB to Serial Cable Driver
2) Run Setup.exe(By double clicking on Setup.exe)
3) Driver installation setup will run and guide the necessary steps.


For All 64 bit Operating System
(Windows XP, Windows Vista, Windows 7)

1) Explore the following path.
	C:\Program Files(x86)\GENIE-NX\G-SOFT NX II\USB to Serial Cable Driver
2) Run Setup.exe(By double clicking on Setup.exe)
3) Driver installation setup will run and guide the necessary steps.

Note: Above all paths are valid only when software is installed on Default installation path.
If Default installation path is changed then Go to respective installation path.
